§ 62.7325 Identification of plan.

(a) Identification of plan. New Hampshire Plan for the Control of Designated Pollutants from Existing Plants (Section 111(d) Plan). (b) The plan was officially submitted as follows: (1) Control of total reduced sulfur (TRS) emissions from existing kraft pulp mills, submitted on January 3, 1992. (2)-(3)[Reserved] (4) Control of air emissions from existing large and small municipal waste combustors, submitted on August 16, 2002. (i) Revised State Plan for Large and Small Municipal Waste Combustors was submitted on January 29, 2009, with a technical amendment submitted on February 13, 2009. Revisions included amendments to New Hampshire Code of Administrative Rules Env-A 3300 Municipal Waste Combustion in response to amended emission guidelines for Large MWCs (40 CFR Part 60, Subpart Cb) published on May 10, 2006 and emission limits for Small MWCs enacted by the New Hampshire General Court in 2005 and codified at New Hampshire Revised Statutes Annotated 125-C:10-a. (ii) Revised State Plan for Large and Small Municipal Waste Combustors was submitted on July 28, 2016. Revisions included amendments to New Hampshire Code of Administrative Rules Env-A 3300 Municipal Waste Combustion in response to more stringent emission limits for Small MWCs enacted by the New Hampshire General Court in 2016 and codified at New Hampshire Revised Statutes Annotated 125-C:10-a. (iii) Revised State Plan for Large and Small Municipal Waste Combustors was submitted on October 1, 2018. Revisions included amendments to New Hampshire Code of Administrative Rules Env-A 3300 Municipal Waste Combustion in response to a change in the state statute relative to “Devices Contributing to Air Pollution” enacted by the New Hampshire General Court in 2016 and codified at New Hampshire Revised Statutes Annotated 125-C:10-c, that incorporates fuel quality standards and test methods for Large MWCs that combust processed wood residue from construction and demolition debris. The plan includes revisions to the regulatory provisions cited in paragraph (d) of this section, which EPA incorporates by reference. (c) Designated facilities. The plan applies to existing facilities in the following categories of sources: (1) Kraft pulp mills. (2)-(3) [Reserved] (4) Municipal waste combustors. (i) Large MWCs with a capacity greater than 250 tons per day. (ii) Small MWCs with a capacity of 250 tons per day or less. (d) Incorporation by reference. (1) The material incorporated by reference in this section was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. You may obtain copies at the EPA Region 1 Regional Office, Air and Radiation Division, 5 Post Office Square-Suite 100, Boston, MA, 617-918-1111 and from the source listed in paragraph (d)(2) of this section. You may also inspect the materials at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fr.inspection@nara.gov, or go to: www.archives.gov/federal-register/cfr/ibr-locations.html. (2) State of New Hampshire, New Hampshire Department of Environmental Services, 29 Hazen Drive, Concord, NH 03302, 603-271-3503, https://www.des.nh.gov/rules-and-regulatory/administrative-rules. (i) New Hampshire Code of Administrative Rules Env-A 3300, “Municipal Waste Combustion,” effective September 27, 2018. (ii) [Reserved]