40 CFR 204.55-3
§ 204.55-3 Configuration identification.
United States · 40 CFR — Protection of Environment · Status: effective
Cite this
- Citation
- 40 CFR 204.55-3, § 204.55-3 Configuration identification, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/184497
- Permanent ID
ys:prov:184497@1- SHA-256
b66600b658b5854119b1fd45e6117f92a8182d3f5835d0022732eee6446bfb91
The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.
Full text
(a) A separate compressor configuration shall be determined by each combination of the following parameters:
(1) The compressor type (screw, sliding vane, etc.).
(2) Number of compressor stages.
(3) Maximum pressure (psi).
(4) Air intake system of compressor:
(i) Number of filters;
(ii) Type of filters.
(5) The engine system:
(i) Number of cylinders and configuration (L-6, V-8, V-12);
(ii) Displacement;
(iii) Horsepower;
(iv) Full load rpm.
(6) Type cooling system, e.g., air cooled, water cooled.
(7) Fan:
(i) Diameter;
(ii) Maximum fan rpm.
(8) The compressor enclosure:
(i) Height, length, and width;
(ii) Acoustic material manufacturer, type, part number.
(9) The induction system (engine):
(i) Natural;
(ii) Turbocharged.
(10) The muffler:
(i) Manufacturer;
(ii) Manufacturer part number;
(iii) Quantity of mufflers used;
(11) Category parameters listed at § 204.55-2.
Legislative history
This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.