40 CFR 420.29
§ 420.29 Point of compliance monitoring.
United States · 40 CFR — Protection of Environment · Status: effective
Cite this
- Citation
- 40 CFR 420.29, § 420.29 Point of compliance monitoring, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/188783
- Permanent ID
ys:prov:188783@1- SHA-256
b9fd8adca223c2e0b54bb73ee3bb57f2f71f185b2f54f3b1d15c21d04b5d0952
The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.
Full text
(a) Sintering direct dischargers. Pursuant to 40 CFR 122.44(i) and 122.45(h), a direct discharger must demonstrate compliance with the effluent limitations and standards for 2,3,7,8-TCDF at the point after treatment of sinter plant wastewater separately or in combination with blast furnace wastewater, but prior to mixing with process wastewaters from processes other than sintering and ironmaking, non-process wastewaters or non-contact cooling water, if such water(s) are in an amount greater than 5 percent by volume of the sintering process wastewaters.
(b) Sintering indirect dischargers. An indirect discharger must demonstrate compliance with the pretreatment standards for 2,3,7,8-TCDF by monitoring at the point after treatment of sinter plant wastewater separately or in combination with blast furnace wastewater, but prior to mixing with process wastewaters from processes other than sintering and ironmaking, non-process wastewaters and non-contact cooling water in an amount greater than 5 percent by volume of the sintering process wastewaters.
Legislative history
This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.