46 CFR 45.39
§ 45.39 Marking.
United States · 46 CFR — Shipping · Status: effective
Cite this
- Citation
- 46 CFR 45.39, § 45.39 Marking, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/224765
- Permanent ID
ys:prov:224765@1- SHA-256
f52c34385b1b31416547e4afa01c220f4f6623f004c4c40c3f76dbe43f7c720f
The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.
Full text
(a) The diamond, lines, and letters must be painted in white or yellow on a dark ground or in black on a light ground and permanently marked on the sides of the vessel.
(b) The upper edge of the line that passes through the center of the diamond must indicate summer freeboard assigned under § 45.53.
(c) Unless otherwise authorized the seasonal load lines must be horizontal lines extending forward of, and at right angles to, a vertical line marked at a distance 26 inches forward of the vertical centerline of the diamond as described in figure 2.
(d) The salt water load lines must be horizontal lines extending abaft the vertical line required by paragraph (b) of this section as described in figure 2.
(e) The upper edge of each seasonal and salt water load line mark must indicate the minimum freeboard for that mark.
(f) When two freeboards assigned under this part differ by 2 inches or less, the line for the lesser freeboard must be omitted and the line for the greater freeboard must be identified with the seasonal letters for both freeboards.
(g) Seasonal freeboards that are limited by a summer freeboard assigned under § 45.53(c) must not be marked but the identifying letter must be marked adjacent to the summer mark.
(h) The identity of the authority that assigns the freeboard must be indicated alongside the load line diamond above the horizontal line that passes through the center of the diamond with two initials approximately 4 1/2 inches high and 3 inches wide.
Legislative history
This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.