yourstate.us
46 CFR 153.1010

§ 153.1010 Alkylene oxides.

United States · 46 CFR — Shipping · Status: effective

Get this as JSONEmbed this
Cite this
Citation
46 CFR 153.1010, § 153.1010 Alkylene oxides, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/228782
Permanent ID
ys:prov:228782@1
SHA-256
494463e01f45301fbbb612b289f38f34b1d8854f5d7bbac76e7f460534500ef5

The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.

Full text

(a) Before each loading of a cargo containment system with a cargo referenced to this section in Table 1, the person in charge of cargo transfer shall: (1) Unless the tankship is equipped with independent cargo piping that meets paragraph (d) of this section: (i) Obtain verification from a Coast Guard Marine Inspector or from a representative of the tankship's flag administration that separation of the alkylene oxide piping system complies with alkylene oxide handling plans approved by the Coast Guard or the tankship's flag administration; and (ii) Make sure that each spectacle flange and blank flange connection that is required to separate alkylene oxide piping systems from other systems has a wire and seal attached by a Coast Guard Marine Inspector or a representative of the tankship's flag administration. (2) Purge the containment system until the oxygen content of the cargo tank is less than 2% by volume. (b) The person in charge of an alkylene oxide cargo transfer shall ensure that: (1) No alkylene oxide vapor or liquid is released to the atmosphere during cargo transfer; (2) No vapor return system connected to an alkylene oxide containment system is at the same time connected to another containment system; (3) Alkylene oxide is discharged only by an intank cargo pump or inert gas displacement; (4) Transfer hose is approved by the Commandant (CG-ENG) under § 153.530(o) for alkylene oxide transfer and is marked “For Alkylene Oxide Transfer Only”; and (5) A water hose is laid out on deck with water pressure to the nozzle, and all alkylene oxide spillages are washed away immediately. (c) While alkylene oxides are onboard the vessel, the master shall make sure that the oxygen content of the vapor space above the alkylene oxide and those spaces specified in § 153.530 (k) and (l) is maintained below 2% by volume. (d) Tankships with independent piping for alkylene oxides must have onboard: (1) Alkylene oxide handling plans approved by the Coast Guard or the tankship's flag administration; and (2) Certification from the Coast Guard or the tankship's flag administration that the cargo piping for alkylene oxides is independent.

Legislative history

This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.