yourstate.us
46 CFR 171.119

§ 171.119 Openings below the weather deck in the side of a vessel less than 100 gross tons.

United States · 46 CFR — Shipping · Status: effective

Get this as JSONEmbed this
Cite this
Citation
46 CFR 171.119, § 171.119 Openings below the weather deck in the side of a vessel less than 100 gross tons, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/230425
Permanent ID
ys:prov:230425@1
SHA-256
94d99568ad392de7c40c01643f34042cff87fb777127598bd890805aa2d0f143

The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.

Full text

(a) If a vessel operates on exposed or partially protected waters, an opening port light is not permitted below the weather deck unless— (1) The sill is at least 30 inches (76.2 centimeters) above the deepest subdivision load line; and (2) It has an inside, hinged dead cover. (b) Except for engine exhausts, each inlet or discharge pipe that penetrates the hull below a line drawn parallel to and at least 6 inches (15.2 centimeters) above the deepest subdivision load line must have means to prevent water from entering the vessel if the pipe fractures or otherwise fails. (c) A positive action valve or cock that is located as close as possible to the hull is an acceptable means for complying with paragraph (b) of this section. (d) If an inlet or discharge pipe is inaccessible, the means for complying with paragraph (b) of this section must be a shut-off valve that is— (1) Operable from the weather deck or other accessible location above the bulkhead deck; and (2) Labeled at the operating point for identity and direction of closing. (e) Any connecting device or valve in a hull penetration must not be cast iron. (f) Each plug cock in an inlet or discharge pipe must have a means, other than a cotter pin, to prevent its loosening or removal from the body.

Legislative history

This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.