47 CFR 15.111
§ 15.111 Antenna power conduction limits for receivers.
United States · 47 CFR — Telecommunication · Status: effective
Cite this
- Citation
- 47 CFR 15.111, § 15.111 Antenna power conduction limits for receivers, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/234409
- Permanent ID
ys:prov:234409@1- SHA-256
28edb1d03b9c8f70585ab3e4c16eaa6bac369e2b97e959b4faab97b667d4c051
The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.
Full text
(a) In addition to the radiated emission limits, receivers that operate (tune) in the frequency range 30 to 960 MHz and CB receivers that provide terminals for the connection of an external receiving antenna may be tested to demonstrate compliance with the provisions of § 15.109 with the antenna terminals shielded and terminated with a resistive termination equal to the impedance specified for the antenna, provided these receivers also comply with the following: With the receiver antenna terminal connected to a resistive termination equal to the impedance specified or employed for the antenna, the power at the antenna terminal at any frequency within the range of measurements specified in § 15.33 shall not exceed 2.0 nanowatts.
(b) CB receivers and receivers that operate (tune) in the frequency range 30 to 960 MHz that are provided only with a permanently attached antenna shall comply with the radiated emission limitations in this part, as measured with the antenna attached.
Legislative history
This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.