§ 80.211 Emission limitations.

The emissions must be attenuated according to the following schedule. (a) The mean power when using emissions H3E, J3E and R3E: (1) On any frequency removed from the assigned frequency by more than 50 percent up to and including 150 percent of the authorized bandwidth: at least 25 dB for transmitters installed before February 1, 1992, at least 28 dB for transmitters installed on or after February 1, 1992; (2) On any frequency removed from the assigned frequency by more than 150 percent up to and including 250 percent of the authorized bandwidth: At least 35 dB; and (3) On any frequency removed from the assigned frequency by more than 250 percent of the authorized bandwidth: At least 43 plus 10log10 (mean power in watts) dB. (b) For transmitters operating in the band 1626.5-1646.5 MHz. In any 4 kHz band the mean power of emissions shall be attenuated below the mean output power of the transmitter as follows: (1) Where the center frequency is removed from the assigned frequency by more than 50 percent up to and including 100 percent of the authorized bandwidth: At least 25 dB; (2) Where the center frequency is removed from the assigned frequency by more than 100 percent up to 250 percent of the authorized bandwidth: At least 35 dB; and (3) On any frequency removed from the assigned frequency by more than 250 percent of the authorized bandwidth: At least 43 plus 10log10 (mean power in watts) dB. (c) In any 4 kHz band the peak power of spurious emissions and noise at the input to the transmit antenna must be attenuated below the peak output power of the station as follows: (1) 125 dB at 1525.0 MHz, increasing linearly to 90 dB at 1612.5 MHz; (2) 90 dB at 1612.5 MHz increasing linearly to 60 dB at 1624.0 MHz; (3) 90 dB from 1624.0 MHz to 1650.0 MHz, except at frequencies near the transmitted carrier where the requirements of paragraphs (b)(1) through (3) of this section, apply; (4) 60 dB at 1650.0 MHz decreasing linearly to 90 dB at 1662.5 MHz; (5) 90 dB at 1662.5 MHz decreasing linearly to 125 dB at 1752.5 MHz; and (6) 125 dB outside above range, except for harmonics which must comply with (b)(3) of this section. (d) The mean power of emissions from radiotelephone survival craft transmitters, 9 GHz search and rescue transponders, and radiotelegraph survival craft transmitters must be attenuated below the mean output power of the transmitter as follows: (1) On any frequency removed from the assigned frequency by more than 50 percent, up to and including 100 percent of the authorized bandwidth: at least 25 dB; (2) On any frequency removed from the assigned frequency by more than 100 percent of the authorized bandwidth: at least 30 dB. (e) The mean power of EPIRBs operating on 121.500 MHz, 243.000 MHz and 406.0-406.1 MHz must be as follows: (1) On any frequency removed from the assigned frequency by more than 50 percent, up to and including 100 percent of the authorized bandwidth: At least 25 dB; (2) On any frequency removed from the assigned frequency by more than 100 percent: at least 30 dB. (f) The mean power when using emissions other than those in paragraphs (a), (b), (c) and (d) of this section: (1) On any frequency removed from the assigned frequency by more than 50 percent up to and including 100 percent of the authorized bandwidth: At least 25 dB; (2) On any frequency removed from the assigned frequency by more than 100 percent up to and including 250 percent of the authorized bandwidth: At least 35 dB; and (3) On any frequency removed from the assigned frequency by more than 250 percent of the authorized bandwidth: At least 43 plus 10log10 (mean power in watts) dB.