Moped equipment requirements and inspection

(a) Every moped offered for sale for use upon, sold for use upon, or used upon the roadways and highways shall be equipped with: (1) A motor having a maximum power output capability, measured at the motor output shaft, in accordance with SAE International standards, of two horsepower (one thousand four hundred ninety-two watts) or less and, if it is a combustion engine, a maximum piston or rotor displacement of 3.05 cubic inches (fifty cubic centimeters) and that will propel the moped, unassisted, on a level surface at a maximum speed no greater than thirty miles per hour; provided that those mopeds, including those modified pursuant to section 291C-206, registered prior to April 23, 1998, shall continue to be subject to the prior thirty-five miles per hour maximum speed limitation; and (2) A direct or automatic power drive system that requires no clutch or gear shift operation by the moped driver after the drive system is engaged with the power unit. (b) The director of transportation by rules and regulations, pursuant to chapter 91, shall establish criteria which shall comply with approved federal regulations for the following moped equipment: brake system; fuel system components; exhaust system components; steering system; handlebars; wheel rims; fenders; a guard or protective covering for drive belts, chains and rotating components; seat or saddle; lamps and reflectors; equipment controls; speedometer; retracting stand; horn; and identification markings. (c) The director of transportation by rules and regulations, pursuant to chapter 91, shall establish criteria and procedures for the annual safety inspection of every moped. Safety inspection criteria shall include the criteria established by the director of transportation under subsection (b).