Or. Rev. Stat. § 447.310
Standards for curbing
Oregon · Oregon Revised Statutes Chapter 447 — Plumbing; Architectural Barriers · Status: effective
Cite this
- Citation
- Or. Rev. Stat. § 447.310, Standards for curbing, Oregon, version 1 as recorded 2026-10-04, yourstate.us, https://yourstate.us/provision/2511271
- Permanent ID
ys:prov:2511271@1- SHA-256
f3fcfa5b418eea6ad7bf50dbbd05921f6f263360dbbcb6f16c830627f99926cd
The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.
Full text
(1) The standard for construction of curbs on each side of any city street, county road or state highway, or any connecting street, road or highway for which curbs and sidewalks have been prescribed by the governing body of the city or county or Department of Transportation having jurisdiction thereover, shall require not less than two curb cuts or ramps per lineal block to be located on or near the crosswalks at intersections. Each curb cut or ramp shall be at least 48 inches wide, where possible, and a minimum of 36 inches wide where a 48-inch width will not fit, at a slope not to exceed one-inch rise per 12-inch run. If a slope of 1:12 will not fit, a slope between 1:10 and 1:12 is allowed for a maximum rise of six inches and a slope between 1:8 and 1:10 is allowed for a maximum rise of three inches. In no case shall the slope exceed 1:8.
(2) Standards set for curb cuts and ramps under subsection (1) of this section shall apply whenever a curb or sidewalk is constructed or replaced at any point in a block which gives reasonable access to a crosswalk.