yourstate.us
14 CFR 121.358

§ 121.358 Low-altitude windshear system equipment requirements.

United States · 14 CFR — Aeronautics and Space · Status: effective

Get this as JSONEmbed this
Cite this
Citation
14 CFR 121.358, § 121.358 Low-altitude windshear system equipment requirements, United States, version 1 as recorded 2026-07-09, yourstate.us, https://yourstate.us/provision/56760
Permanent ID
ys:prov:56760@1
SHA-256
a8b3a5c9b8a1dd61b544f5d952f87d7e800d86ae865e1863bccf0937dd91a468

The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.

Full text

(a) Airplanes manufactured after January 2, 1991. No person may operate a turbine-powered airplane manufactured after January 2, 1991, unless it is equipped with either an approved airborne windshear warning and flight guidance system, an approved airborne detection and avoidance system, or an approved combination of these systems. (b) Airplanes manufactured before January 3, 1991. Except as provided in paragraph (c) of this section, after January 2, 1991, no person may operate a turbine-powered airplane manufactured before January 3, 1991 unless it meets one of the following requirements as applicable. (1) The makes/models/series listed below must be equipped with either an approved airborne windshear warning and flight guidance system, an approved airborne detection and avoidance system, or an approved combination of these systems: (i) A-300-600; (ii) A-310—all series; (iii) A-320—all series; (iv) B-737-300, 400, and 500 series; (v) B-747-400; (vi) B-757—all series; (vii) B-767—all series; (viii) F-100—all series; (ix) MD-11—all series; and (x) MD-80 series equipped with an EFIS and Honeywell-970 digital flight guidance computer. (2) All other turbine-powered airplanes not listed above must be equipped with as a minimum requirement, an approved airborne windshear warning system. These airplanes may be equipped with an approved airborne windshear detection and avoidance system, or an approved combination of these systems. (c) Extension of the compliance date. A certificate holder may obtain an extension of the compliance date in paragraph (b) of this section if it obtains FAA approval of a retrofit schedule. To obtain approval of a retrofit schedule and show continued compliance with that schedule, a certificate holder must do the following: (1) Submit a request for approval of a retrofit schedule by June 1, 1990, to the appropriate Flight Standards division manager in the responsible Flight Standards office. (2) Show that all of the certificate holder's airplanes required to be equipped in accordance with this section will be equipped by the final compliance date established for TCAS II retrofit. (3) Comply with its retrofit schedule and submit status reports containing information acceptable to the Administrator. The initial report must be submitted by January 2, 1991, and subsequent reports must be submitted every six months thereafter until completion of the schedule. The reports must be submitted to the certificate holder's assigned Principal Avionics Inspector. (d) Definitions. For the purposes of this section the following definitions apply— (1) Turbine-powered airplane includes, e.g., turbofan-, turbojet-, propfan-, and ultra-high bypass fan-powered airplanes. The definition specifically excludes turbopropeller-powered airplanes. (2) An airplane is considered manufactured on the date the inspection acceptance records reflect that the airplane is complete and meets the FAA Approved Type Design data.

Legislative history

This is a federal regulation, adopted through agency rulemaking under the Administrative Procedure Act — not enacted by a recorded vote of Congress.