Cal. Business and Professions Code § 9889.30

California · California Business and Professions Code · Status: effective · Effective 2020-01-01

Cite this

Citation: Cal. Business and Professions Code § 9889.30, California, version 1 as recorded 2026-07-25, yourstate.us, https://yourstate.us/provision/776883
Permanent ID: ys:prov:776883@1
SHA-256: 9f46625430ae177bdaeba10a8c1ba1a9a022965878046aa030ac134f5a60c641

The hash is SHA-256 of this version's text, with every run of whitespace collapsed to a single space and the ends trimmed. The ID always leads back here, and checking it says whether the text you cited is still the current version.

Full text

(a) (1) Subject to subdivision (b), an automotive repair dealer shall not install an unsafe used tire on a motor vehicle for use on a highway, as defined in Section 360 of the Vehicle Code. (2) For purposes of this section, “unsafe used tire” means a used tire to which any of the following criteria applies: (A) The tire is worn to two thirty-seconds of one inch tread depth or less on any area of the tread. (B) The tire has any damage exposing the reinforcing plies of the tire, through cuts, cracks, punctures, scrapes, or wear. (C) The tire has any repair in the tread shoulder or belt edge area. (D) The tire has a puncture that has not been both sealed or patched on the inside and repaired with a cured rubber stem through to the outside. (E) The tire has repair to the sidewall or bead area. (F) The tire has a puncture repair of damage larger than one-fourth of one inch. (G) The tire shows evidence of prior use of a temporary tire sealant to repair a puncture or damage to the tire without evidence of a subsequent proper repair. (H) The tire has a defaced or removed United States Department of Transportation tire identification number. (I) The tire has any inner liner damage or bead damage. (J) The tire shows indication of internal separation, such as bulges or local areas of irregular tread wear indicating a distortion in the tread area when compared to other areas of the tread, or belt separation. (b) This section does not apply to tire repairs, tire rotations, tire balancing, or a tire mounted on a wheel or rim that is temporarily removed from a vehicle and reinstalled on the same vehicle. As used in this subdivision, “tire repair” means repairing a puncture in the tire tread area that is no larger than one-fourth of one inch in diameter, has not caused any internal damage to the tire, and is repaired according to industry standards. (c) Except as set forth in subparagraph (A) of paragraph (2) of subdivision (a), an automotive repair dealer shall use a visual inspection to determine whether a tire meets the criteria of an unsafe used tire.